What version of Atom 3D?I don't see midpoints when using Atom3D....
Are you trying to select the midpoint of an edge of the surface you're sketching on? Because if that's the case, the edge has to be "active" first. If you select it as a reference for something else, it should automatically be traced over by a reference line, and anything you bring near the center of that reference line should perk up a Midpoint constraint (along with your usual Coincident, Parallel, endpoints, etc.)V24
To clarify. I can see midpoints when sketching. BUT.. If I pick a surface on a model to sketch on then
I can't see midpoints while sketching.
Midpoints are only visible on reference and sketch lines, not geometry edges. Use project to sketch to create a reference line of an edge then use it's midpoints.To clarify. I can see midpoints when sketching. BUT.. If I pick a surface on a model to sketch on then
I can't see midpoints while sketching.
Ok... I'm sure your right. I'll work on it. Thank You!Midpoints are only visible on reference and sketch lines, not geometry edges. Use project to sketch to create a reference line of an edge then use it's midpoints.
Create a horizontal reference line on the top edge. Create a vertical reference from that refence lines midpoint. centre constrain the vertical rectangle sides about the vertical reference line.I'm trying to align the midpoint of the top edge of the sketched rectangle with the top edge of the solid rectangle
without moving the sketch up or down. Crummy explanation.. hope it makes sense.