Recent content by pc-6

Thanks fellows, that's exactly what I needed, just a push in the right direction. Worked like a charm.

Hello everyone, I'm looking for a way to model treads on tires such as the diamond pattern on may aircraft like the B-25 Mitchell. Any suggestions as to how this is accomplished would be appreciated.

DavidJ, dwc You are correct in your clarification, all settings remained the same. There were no updates of any kind on the computer. I have checked the settings at the top of the STL export window and it is set correctly. I always export in millimeters as a standard practice. I tried changing...

I created a part which I saved as a STL file, loaded into my slicer for 3D printer. After print I needed to adjust some parameters. I made the adjustments and resaved the STL file. When I reloaded it into the slicer program I got a message saying that the dimensions were to large and it would...

Thanks for your help, it worked perfectly. Great to now know how to use 2d guide curves.

Sebastian, Thank you for the input. Unfortunately I can not open the file as my version is just slightly older than yours, I have version 18.0.3.1842 I have never been able to create a 2d guide curve for this purpose, not sure if it is a bug or an error on my part, probably the latter. My...

Hello everyone, I am having issues with the attached file. The design is one half of a cover for a small bottle. When I loft the 3 sketches without the guide curves, the loft will complete, however when I try it with the 3d guide curve it fails. This is not the first time I have had this problem...

Thanks for everybody's input. Been going round and round in circles and no joy so far with all the ideas. I have loved Alibre up to this point but perhaps it might be time to switch programs (Hoping Alibre staff are paying attention). Cheers

I'm Having a similar problem. While drawing up a replacement part for the flush button on a toilet which requires a threaded part I get the same transparent surface if the helix is extruded to some lengths. Other lengths seem to be fine. To try and work around this I have drawn the helix to a...

That was exactly it. Put STL output in millimeters and that fixed it. Thank you, Leif

I have created a simple part in Geomagic. When I save it as a STL file and then import it in Repetier to print, the size of the part is reduced significantly. The part is a simple round disc with a hole in the center. Outer diameter is 5/16 with a hole in the center of 1/8 and a thickness of...

Oldbelt You are correct, the original did not have this. However, this part creation will be used to make a plug which will be used to vacuum form the windshield. This will then be cut to match the shape of the full size. This cut will eliminate the portion that has the sharp corners. Leif

Ralf Thank you so much for fixing this. What needed to be corrected to make this work properly? Leif

I realize it is not yet a closed sketch. I have been trying to modify it from its original shape that matches what you have shown in your second posted image. The updated sketch should include line 4 which will cut off the lower part of the spline. I have started this modified drawing but it...

OK I have cleaned everything up and the loft seems to work fine but I still have that uneven surface at 3D sketch 6. When I cleaned up the "Bottom of WS" sketch I took out one half of the spline with the small segment of a straight line. I then mirrored the remaining side over so now there is...