Search results

Hi I need to offset, all the faces, on the inside of this model. Offset distance can be 0mm. Any advice?

Hi Anyone know how to add tabs to a sheet metal pipe? (Please view attached pic of sheet metal part I need to design)

Hi Anyone able to assist on putting a surface on this?

Hi Guys. I downloaded a model of a double torsional spring from a free CAD model site, which is attached. I tried to model a duplicate of this, but without success. I can model the spring on its own but adding the wire form onto it, is a challenge. Any suggestions? Thanks

Hi When I delete parts off my main assembly, that the parts deleted are not updated on the 2D drawings of the main assembly. This only happens on drawings of assemblies, not part drawings. Any reason for this? Thanks

Hi Is there a function in detailing of a flat pattern, sheet metal drawing, to indicate whether the bending is either "up" or "down"? I find it tedious doing it manually, and subject to human error. Thanks

Hi Is there a command to project or copy a sketch, from one sketch plane to another parallel plane?

Hi I am trying to remove to subtract the shelled cad model (vacuumed formed part) from the block to get a positive tool and I get errors. Any suggestions? Thanks

Hi As an ex Solidworks user I find looking for constraints cumbersome. In Solidworks you click a part in an assembly and selected "view mates". Is there a short cut in Alibre too? (Instead of looking for the part name in design explorer in order to find the constraints) This can be time...

Hi Can you reverse a bend in sheet metal? Tried editing the sketch but no luck

Hi All I am trying to trim a lofted sheet metal half cylinder (in grey) with the blue surface. Is this possible with Alibre Expert?