What's new

Search results

  1. J

    Drrawings are a nightmare now

    1. if I pull up an old drawing, the dimensions are no longer attached so I have to start over 2. You can’t find out what scale the drawing is because one source says it’s 1 to 1 and the other one says it’s 2 to 1. 3. I can’t edit the part from one drawing I have. When I write click on it there...
  2. J

    Dimension tool doesn’t work

    The dimensions on one of my older Alibre drawings are completely messed up. The plus or minus tolerance overlaps the dimensions so you can’t read it. You try to remove it and re-dimension it and it won’t dimension between two holes. It only dimensions the hole. You go out of sketch mode and that...
Top