Search results

Documentation says it cant be done. Any suggestions on how I would accomplish this? Lofting the sketch on YZ to the sketch on XZ along the 1/4 ellipse on YX plane and the origin. Any help would be appreciated. Thanks Todd

I am trying to find a simple 4-40 cup point set screw in Traceparts. I cant even seem to find the ANSI section. EVERYTHING is METRIC! I remember imperial sizes were hard to find but now I cant find them at all! Any direction would be appreciated. Thanks Todd

Is there a keyboard short cut for the "Insert Assembly constraint"? I have found the "Quick Constraint" <cntl>Q but I do not know where/how to set up the "Insert Assembly constraint" keyboard shortcut.

Group, Is there a way to get Alibre to automatically add the drill bit number to a drawing/part when a hole is specified. For example: if I select a 6-32 UNC-2B from the insert Hole pop-up with the source specified as Tap drill diameter. The Hole call out it will display ".115 6-32 UNC". I...