What's new

2D drawing threads call out and cosmetic threads not shown

evandene

Member
Need help please,
In release V26, When creating parts with external threads, I can't show the cosmetic thread neither is it possible to generate a thread call out.
Is this a release bug? See attached model plus drawing
 

Attachments

  • 08032023-9-BOTTOM_CAP_rev0.AD_DRW
    478 KB · Views: 6
  • BOTTOM_CAP_rev0.AD_PRT
    425 KB · Views: 7

Nick952

Senior Member
On the Model, move the Thread to after the end cut (Extrusion <2>) and it should then work as you need in the drawing.

Edit:- Added the jpg file as Davidj was also replying. Then also added Model file
 

Attachments

  • Thread.jpg
    Thread.jpg
    189.2 KB · Views: 35
  • BOTTOM_CAP_REV 1.AD_PRT
    628.5 KB · Views: 3
Last edited:

DavidJ

Administrator
Staff member
Extrude cut 2 is the problem, it cuts away part of the chamfer created by the external thread.

If you un-check create chamfer in the external thread, and instead add a small chamfer (0.436mm) after Extrude cut 2, so you get same final shape, it'll work.
 

HaroldL

Alibre Super User
On the Model, move the Thread to after the end cut (Extrusion <2>) and it should then work as you need in the drawing.

Edit:- Added the jpg file as Davidj was also replying. Then also added Model file
Why is the M18 thread call out not connected to the part? Is this a bug? Maybe Dev could look into this.
I've seen this before on other drawings and need to manually move the leader so it is connected to the threaded part.
 
Top