3D Connexion (CadMan) rotation bug.
Could someone with a CadMan (or any 3d Connexion device for that matter) kindly try to replicate the following:
Default rotation point for a new part is "volume". After setting an alternative rotation point, it is not possible to revert to "volume" or "mass" as the centre of rotation. Setting "volume" or "mass" gives a rotation point of "origin". This anomalous behaviour only applies to my CadMan - using the left&right mouse buttons to rotate, the centre of rotation is correctly placed.
Thanks,
Miles
PS Yes, I have the latest 3D Connexion driver.
Could someone with a CadMan (or any 3d Connexion device for that matter) kindly try to replicate the following:
Default rotation point for a new part is "volume". After setting an alternative rotation point, it is not possible to revert to "volume" or "mass" as the centre of rotation. Setting "volume" or "mass" gives a rotation point of "origin". This anomalous behaviour only applies to my CadMan - using the left&right mouse buttons to rotate, the centre of rotation is correctly placed.
Thanks,
Miles
PS Yes, I have the latest 3D Connexion driver.