albie0803
Alibre Super User
Tangent planes being created below the referenced plane with the normal facing up into the cylindrical face is something I find quite annoying.
These sorts of planes are normally used for positioning features like holes which then require the the hole to be reversed.
Another thing is that when you edit the sketch on the plane later, it opens with the part on top of the sketch. so that X measurements are reversed to the way you would normally look at it, causing then a need to use the reset view function to flip it around to the correct view.
If you create a plane on any other face the normal is always facing out.
I would really like either the plane to be created in the reverse view by default (probably the easiest) or make it so that the normal always points out.
Does it frustrate anyone else?
These sorts of planes are normally used for positioning features like holes which then require the the hole to be reversed.
Another thing is that when you edit the sketch on the plane later, it opens with the part on top of the sketch. so that X measurements are reversed to the way you would normally look at it, causing then a need to use the reset view function to flip it around to the correct view.
If you create a plane on any other face the normal is always facing out.
I would really like either the plane to be created in the reverse view by default (probably the easiest) or make it so that the normal always points out.
Does it frustrate anyone else?