papajoe41
Senior Member
Hi,
I just need to know how I can elongate that semicircle to a slot. I have tried the equations, but, am not sure of what to do. I see how as I add dimensions to my drawing it registers into the equation. My trouble is how do I add a slot depth to those measurements? I can always draw it as a square slot and have the cutter diameter create it. But, if I use a smaller diameter cutter, it would be nice to get a full radius at that point.
Thanks,
Papajoe41
I just need to know how I can elongate that semicircle to a slot. I have tried the equations, but, am not sure of what to do. I see how as I add dimensions to my drawing it registers into the equation. My trouble is how do I add a slot depth to those measurements? I can always draw it as a square slot and have the cutter diameter create it. But, if I use a smaller diameter cutter, it would be nice to get a full radius at that point.
Thanks,
Papajoe41