powerAlibre
New Member
I have a fairly large assembly that in previous versions had some association issues. I created a new assembly from scratch to try to fix the issue. I didn't redraw each individual part but I created an entirely new top level assembly and broke it down into four different sub assemblies to make the file less crowded.
I went through each part and assembly to make sure they open correctly and aren't corrupted. The top level assembly opens and works perfectly. The issue only occurs when sending to a drawing. I am trying to create a new drawing; It lets me choose template and views as normal, but when I try to put the views on the sheet (I have even tried just a single view) it tries to load for a minute and then the entire program crashes. I have also tried doing it in an existing drawing and have had the same issue.
Any suggestions to fix this? I am using the most recent update Alibre Design Expert V28
I went through each part and assembly to make sure they open correctly and aren't corrupted. The top level assembly opens and works perfectly. The issue only occurs when sending to a drawing. I am trying to create a new drawing; It lets me choose template and views as normal, but when I try to put the views on the sheet (I have even tried just a single view) it tries to load for a minute and then the entire program crashes. I have also tried doing it in an existing drawing and have had the same issue.
Any suggestions to fix this? I am using the most recent update Alibre Design Expert V28
