Assembly Sketches & Features?
Is it possible to create an assembly of several parts and then from the assembly, sketch a hole on one of the parts and then extrude it through the assembly?
Further, if this is possible, can you then drive the new hole BACK to the original parts?
I'm trying to create an assembly of sheet metal parts and would like to apply the holes AFTER the assembly where I can apply the holes for fasteners in the context of the assembly vs at the piece part level.
Thanks!
Bill
Is it possible to create an assembly of several parts and then from the assembly, sketch a hole on one of the parts and then extrude it through the assembly?
Further, if this is possible, can you then drive the new hole BACK to the original parts?
I'm trying to create an assembly of sheet metal parts and would like to apply the holes AFTER the assembly where I can apply the holes for fasteners in the context of the assembly vs at the piece part level.
Thanks!
Bill