Hello all.
I haven't used Alibre for a few months, so I am reacquainting myself with it. The reason for that was that my old laptop was struggling with Alibre, and I had an old version of Solidworks which it could run. I've recently replaced my laptop , so I am back with Atom3D.
I seem to recall that I was able to copy and paste sketches from Solidworks into Atom3D, but find I cannot now. I highlight the sketch items, then Control C in SW, then jump over to Atom3D sketch sheet and Control V, but nothing happens - or at least, nothing appears to happen.
Now I wonder if I am missing something in the page/sheet set-up? Has something changed going to V22 that changes this from happening?
It's also possible that my memory is faulty and I didn't do this in Solidworks to Atom, but instead AutoCAD to Atom, although I am pretty certain it did....I remember thinking that this was going to come in handy as it would save me having to redraw things I have done in Solidworks.
Regards,
Michael
I haven't used Alibre for a few months, so I am reacquainting myself with it. The reason for that was that my old laptop was struggling with Alibre, and I had an old version of Solidworks which it could run. I've recently replaced my laptop , so I am back with Atom3D.
I seem to recall that I was able to copy and paste sketches from Solidworks into Atom3D, but find I cannot now. I highlight the sketch items, then Control C in SW, then jump over to Atom3D sketch sheet and Control V, but nothing happens - or at least, nothing appears to happen.
Now I wonder if I am missing something in the page/sheet set-up? Has something changed going to V22 that changes this from happening?
It's also possible that my memory is faulty and I didn't do this in Solidworks to Atom, but instead AutoCAD to Atom, although I am pretty certain it did....I remember thinking that this was going to come in handy as it would save me having to redraw things I have done in Solidworks.
Regards,
Michael