When I export the design below to a STL file. The holes become rectangular, instead of circular, when opened in the Cura slicer.
The Atom3d software was downloaded today, 11/30/2021
I made the same item using 3D Viewer that comes with windows. The holes came out circular when opened in the slicer.
Note that the holes are counter sunk if that makes any difference.
I attached the design file.
Any ideas?
Atom3d editor
Cura Slicer preview
I just downloaded the software today, 11/30/2021
I made the same item in 3D Viewer that comes with windows. The holes came out circular.
The Atom3d software was downloaded today, 11/30/2021
I made the same item using 3D Viewer that comes with windows. The holes came out circular when opened in the slicer.
Note that the holes are counter sunk if that makes any difference.
I attached the design file.
Any ideas?
Atom3d editor
Cura Slicer preview
I just downloaded the software today, 11/30/2021
I made the same item in 3D Viewer that comes with windows. The holes came out circular.