Division09
New Member
Using Expert, Model Tab. Revolve Cut...
Following a tutorial, I've sketched a profile to remove an o-ring groove around the circumferencial edge of a brace (Z Axis).
The individual profiles position properly around the part, but after clicking OK, the surface edge displays, not removed material.
Any advice?
Thanks.
...and thanks again to everyone that offered tutorial suggestions on my previous thread. I did the above drawing after one day of online training! Feeling VERY appreciative!
Following a tutorial, I've sketched a profile to remove an o-ring groove around the circumferencial edge of a brace (Z Axis).
The individual profiles position properly around the part, but after clicking OK, the surface edge displays, not removed material.
Any advice?
Thanks.
...and thanks again to everyone that offered tutorial suggestions on my previous thread. I did the above drawing after one day of online training! Feeling VERY appreciative!