Dave H
Senior Member
Been away from Alibre for a while and I'm rusty (and older!)
I've been trying to figure out how to model two rotated slots 180 degrees apart through a piece of tubing. The ends of the slots have to be rounded as if the
slots were cut with an end mill. (cuz they will be) They have to line up so a dowel would go through both sides of the tube and be able to follow the slots axially when the
tube is rotated. Similar to a hollow barrel cam. Anybody willing to help with this?
I am using Expert 2018 version if that matters. TIA!
Dave
I've been trying to figure out how to model two rotated slots 180 degrees apart through a piece of tubing. The ends of the slots have to be rounded as if the
slots were cut with an end mill. (cuz they will be) They have to line up so a dowel would go through both sides of the tube and be able to follow the slots axially when the
tube is rotated. Similar to a hollow barrel cam. Anybody willing to help with this?
I am using Expert 2018 version if that matters. TIA!
Dave