splines to reg geometry
Alex... another one for you....
see the following post
http://www.alibre.com/forum/viewtopic.php?p=12875#12875
For splines that approximate an arc, for example, but are not truely an arc, convert the spline to an arc. You will likely need to do this in the Part Sketch environment. You could output the error (deviation from being a perfect figure).
Alex... another one for you....
see the following post
http://www.alibre.com/forum/viewtopic.php?p=12875#12875
For splines that approximate an arc, for example, but are not truely an arc, convert the spline to an arc. You will likely need to do this in the Part Sketch environment. You could output the error (deviation from being a perfect figure).