ElsGray
Member
I’m using netfabb Studio Basic 4.9 to check my stl files before uploading to an RP service (Shapeways).
When I open the stl file it is not the size of the model as designed. It shows X = 0.69” Y = 0.17” Z = 3.42”
The model sizes should be X = 1.752” Y = 0.439” Z = 8.675”.
Can you shed some light on what is going on with the Alibre STL export? The STL system settings are not very clear on sizing the stl to be exported.
All help will be greatly appreciated..
Els Gray
Milwaukee WI
When I open the stl file it is not the size of the model as designed. It shows X = 0.69” Y = 0.17” Z = 3.42”
The model sizes should be X = 1.752” Y = 0.439” Z = 8.675”.
Can you shed some light on what is going on with the Alibre STL export? The STL system settings are not very clear on sizing the stl to be exported.
All help will be greatly appreciated..
Els Gray
Milwaukee WI