Hello David,
as far as i do not need such features, i did not have tried it up to now...
I opened the "Tracing Image Dialog"
I loaded a picture to the xy-plane and pressed "Calibrate".
I picked the two "end points" of the measurement:
then i entered the desired value:
then i pressed "return" on my keyboard:
pressed "OK" to close the dialog.
I reopened the "Tracing Image Dialog" and pressed "Calibrate Size" and picked the same points as in the first attempt on the calibrated image:
As far as the input values are "automatically" corrected to 1 decimal it is what expected...
but i think that this should be so...
Regards
Stefan
Edit: So, a few hours later, sarcasm mode off, no further reaction. If i haven't used it wrong, the Scaling function works wrong for my opinion. Sarcasm mode on, Good, that i don't need this function...