NigelL
Member
If you select an edge or surface, and click-hold both right and left mouse buttons, one can orient the part round the selected edge/surface using the mouse.
What I discovered is that you can then also use a 3D Mouse to orient the part - far more easily - while still holding the right and left mouse button down. This is especially useful for zooming in and inspecting small features that are far away from the centre of mass.
What I discovered is that you can then also use a 3D Mouse to orient the part - far more easily - while still holding the right and left mouse button down. This is especially useful for zooming in and inspecting small features that are far away from the centre of mass.