Hello, everyone.
I had some trouble applying a .02" fillet to one area of edges, but I cannot repeat this operation on the opposite side. If I pick a single corner, a different edge is filleted. If I select the rectangular area, I get an error message that says the target is no longer available. Would someone take a look at this model and try to duplicate the fillets already created on one side, on the opposite side?
I had some trouble applying a .02" fillet to one area of edges, but I cannot repeat this operation on the opposite side. If I pick a single corner, a different edge is filleted. If I select the rectangular area, I get an error message that says the target is no longer available. Would someone take a look at this model and try to duplicate the fillets already created on one side, on the opposite side?