Jake_Steidy
Senior Member
Hope everyone has been doing well.
Curious if there is any way to prevent what I am going to describe.
A 0.0625" line, 1/16", is drawn you offset that line by, N inches, you now have two lines that are supposed to be 0.0625", one is dimensioned the other is not dimensioned, mag/pos undefined. You go to dimension that line, and are presented with a dimension 0.063", which is not what the original line was drawn at. The dimension should be 0.0625". Is there anyway to prevent Alibre from creating these rounding design errors in the options menu?
Thanks,
Jake
Curious if there is any way to prevent what I am going to describe.
A 0.0625" line, 1/16", is drawn you offset that line by, N inches, you now have two lines that are supposed to be 0.0625", one is dimensioned the other is not dimensioned, mag/pos undefined. You go to dimension that line, and are presented with a dimension 0.063", which is not what the original line was drawn at. The dimension should be 0.0625". Is there anyway to prevent Alibre from creating these rounding design errors in the options menu?
Thanks,
Jake