Recent content by MikeStrickland

yes, that was the only workaround I could find. Just unwelcome when all the designs and all their different configs were done as part files rather than SMP; creates a lot of work I wasn't banking on. ho-hum.

I'm on Alibre Design 25.0.1.25037 A very simple part is giving me problems. It's basically like the attached 'new part (1)' file. Two simple folds, and a cut going through into the bend radius region. ('extrusion 3' is optional, it just puts a 90° edge on the cut; but the effect is the same...

Hello, first-time forum poster, just signed up. I thought I'd ask on this issue as it was several years ago and maybe there is now a better solution? I often have the same problem, where files have been left called 'new part' or moved around the place on the network drive. I know there is the...

using resource monitor to see open filenames