Latest activity
-
-
-
Hi, I have upgraded from a more than ten year old Intel i7 to AMD Ryzen 7 / 64 Gb RAM / 1 Tb SSD / RTX 3070 graphic card / Win 11. A... -
Ken226 replied to the thread Rotated slots through a tube.On my test file above, the text and the A logo were separate sketches. Both failed wrap, but for different reasons. The A sketch...
-
simonb65 replied to the thread adding to addons.@danwrnr11, just to help a little bit more, here is a bit of test code that is in C# and is in the button pressed handler for an Add-On... -
Am I the only one who thinks the hole tool is pretty bad? I try to avoid having to use it. It makes my PC run sluggishly, and it... -
Ken226 replied to the thread Rotated slots through a tube."Project" seems to work great. But i can't get wrap to work with anything but really simple geometry. The same sketches that work fine...
-
-
Ken226 replied to the thread Modeling a helical staircase?.I had a go at it in the modeling workspace. Its probably tougher than doing it in an assembly, but with a series of angled planes, its...
-
-
Martinm replied to the thread Modeling a helical staircase?.I see, tried to model this in a part where the circular/linear combination is unavailble. Thanks for the hint! Martin -
TTCB replied to the thread A little help on constraints and lack of motion in the Crank/Pulley tutorial assembly.Thanks for you all looking at this. Like I said, I'm going back and start from scratch on the tutorial later next week when I'm back in...
-
Hi all, I'd like to model a helical staircase: Draw one step, then pattern it upwards linearly and at the same time rotating it around...
-
dwc replied to the thread Create a ionternal gear correct workflow.You will have to do try and error, it depends on the characteristics of your printer. That 0.4mm tolerance recommendation is way too... -
albie0803 replied to the thread A little help on constraints and lack of motion in the Crank/Pulley tutorial assembly.Hmmm, I initially got the result as you but then I dragged the crank arm closer to the desired position and then tried again and it... -
albie0803 replied to the thread Create a ionternal gear correct workflow.I wouldn't rely on the alibrescript gear shapes. They are not true involute curves, just approximations for virtual models. Also, a...
-
"""" Hi everyone. Lately I have been using Lightburn to move the laser and I find it very convenient to manage the array 1) You can set...
