J
JimCad
Alibre Super User 72
- Joined
- Last seen
- Messages
- 771
- Reaction score
- 500
Latest activity Postings Media About
-
-
JThat particular error message has been around for quite a while and will pop up when least expected.
-
JI pushed F5, it had a bit of a think and then cut away what I was trying to trim. No closing and reopening required. Thanks for that, it...
-
JI usually clear that error message by closing and re-opening the model. You may need to do a Regen (F5) and saving the part before...
-
JV2026.1 recognozes Alibre license.
-
JJimCad reacted to HaroldL's post in the thread New Feature Request: Folders in Design Explorer with
Like.
The DE in an assembly can get pretty long, especially if there are a lot of fasteners or other hardware, as in this example of a tool... -
JOMG! Yes... Thank you so much. I searched and searched... but apparently not well enough.
-
JUncheck Reorient on extrude.
-
JJimCad reacted to cadtec's post in the thread A little game to pass the time and stave off boredom :-) with Like.
My colleague once said it would be cool if we could keep this going until the next manned moon mission... :D It might be a bit of a long...
-
JJimCad reacted to HaroldL's post in the thread Odd Built Machinery and Random Parts for Modeling/Plates, Blocks, and DC Motor Adapters with Like.
Yes it is possible...
-
JYou can edit the section line afterwards if it isn't exactly as you want it. Just right click on the section line and choose Edit. You...
-
JYou need a different workflow. Start a Sketch in View then create a line for the section as long as you need. If you need it to go...
-
JJim I am glad you noticed the bolt, there is another video where it vibrates off. That stand is a rickety old Workmate B.
-
JJimCad replied to the thread 3D Printing Gallery.Very impressive. I also liked watching the bolt underneath the bench as the nut went up and down. Reminded me of Geordie La Forge with...
-
JThe bore is 21mm and the stroke is 18.95mm, power on a good run is north of 4.5 BHP at around 32,000 to 33,000, that run in the video...
-
JJim Here is a link to the 3D printed crankcase running. Around 32,500 rpm and a little rich for this test run.
-
-
Loading…
-
Loading…
-
Loading…
