OK I went to the link and saw that you are using Alibre Photorender,
please post the file soon as I am very keen to check out the light settings.
tia
Teatime
Hi Max,
That looks fantastic, what photo-render package did you use? we have been playing with the Alibre photorender but not obtained very good results.
Here is the reference for the springs http://www.balseal.com/products/springs.php
Challenge - Canted Helical Spring
Hi Alibre Guys with time on their hands,
We are just knocking around a new design that might use a Canted Steel Spring (from Bal-Seal). We have been looking at how we might :D draw it with Alibre.
We have some ideas but probably...
Strangely when IYup, when I run DxDiag, Direct X features are all listed as "Not available"
Direct Draw acceleration: Not Available
Direct 3D acceleration: Not available
AGP texture acceleration: Not Available
Enable buttons are all greyed out and do not read "Enable" but "Disable"...
The Net meeting thing seems to be a hot tip but hasn't cured it.
We have just spent the morning swapping out graphic cards I now have a
NVIDIA GeForce FX5200, guess what? - no change.
dxdiag still says Direct draw acceleration is not available
I have been running Alibre 9.1 for at least a couple of months. So the card must have been running directx 9.0c for the same period.
The IT Guy was fixing a printer delay and an adware issue (turned out to be itunes) but we suspect that its the fact that he was doing it remotely that may be...
Ah,
You've got me there.
I guess if Alibre 9.1 only runs with directx 9.0c then I must have always had directx 9.0c and my old dog of a card must have been able to run it.
Hi Indesign
Thanks for the response
hardware acceleration already "full"
and tried altering the refresh rate
and tried altering the colours (32 to 16 and back again)
and confirmed that Alibre is looking at the correct video card
currently I suspect that as the directx diagnostic is telling...
Thanks for the info guys, however I dont think the fault can lie with the card as
a) The machine has run Alibre perfectly ok right up to last Friday morning
b) The Direct x diagnostic is indicating the fault lies with Directx acceleration not being available, so this seems the most likely...
Toolbars - OK, Part / Drawing not there
Desparate can any body help me? -
When I run DxDiag, Direct X features are all listed as "Not available"
Direct Draw acceleration: Not Available
Direct 3D acceleration: Not available
AGP texture acceleration: Not Available...
Print, Dialogue Box - Long delay
After I click print there is a long delay (nearly 1 1/2 minutes) before the dialogue box appears. The delay seems to be independant of drawing size/complexity and of number of drawings in file. Anybody else have this problem? Any...
Hi Jordan,
you're up early
Yup I can get this far, but the problem now is to accurately project this surface into a flat shape that I can then cut out of cardboard
I am now thinking that maybe it would be easier to cut the strips as horizontal segments.
regards
Teatime
Cardboard Bell Segments- Teatime Challenge
Here is one for you all;
Say you had to make a bell costume for a young Lady's Christmas play
I'm planning
Two or three Stiff wire hoops to keep the shape
cut strips of cardboard in the exact shape of say 30 degree intervals of...