Recent content by UGMENTALCASE

I was trying to figure out how to suppress half the dimension line, where is it please? Yeah I've no issues doing a bit of jiggery pokery but I would say there is something abnormal about dimensions on imported parts. I've known this in other software, like the centre line thing

Foreshorten

Yes, I did. Thinking that maybe the way forward. But it seemed to move the dimension into fresh air

Just to add to this, the parts were an imported stp file. I've set up a file now and it behaves differently. To get the rad in the detail view, I've needed to move the detail circle past the centre line so it updates and appears in the detail view. Dimension from centreline to outside face to...

Hi all, I have a view which shows a step on the part. I've given it a detail view, increased the scale and positioned on the sheet. I then want to dimension the diameters. I thought I'll add a centre line and then dimension to that, then overide the dimension with the figure it should be. Not...

Weirdly when I open my file up now it's got less issues! I tried making a fresh file and it didn't do it, but I can email send it to a staff member but can't post it on here. So long as we can ensure it's deleted at their end once they have looked at it?

I'll do an example of what my file was doing, I can't share the actual file, but I'll try and recreate it

I did a drawing a few weeks ago, so general assembly and a few other sheets. Decided to just hide the parts from the views I didn't need. Did all the dims. Saved it all fine. Opened it up again I'd say 90% of the dims were red. I reassociated them, same again saved. Opened the next day, same...

Some more examples of the manual nurb creation and the auto function.

Example of a simple part.

The software has two modes a simple mode and advanced. Simple is bring in the part. Lets say it's a downloaded stl from something like thingiverse and it's got simple shapes. Rectangles, rads, holes, boss features etc. The simple mode will switch them to a solid and will give you proper...

I have a license for that software so if you want a test piece doing let me know

I just have a set of taps and die. Run it down once it's done to clean it up

https://instepstudio3d.com/ I use this. In basic mode it works well to find cylinders etc and gives nice clean surfaces. In advanced mode you can draw on the surface and generate a nurbs straight from the mesh. It's a little clunky, didn't do as well as they thought so not a huge amount of...

Let's say you have the hole in, then it needs modifying with a pocket down the line. Are you telling me you would take the hole out, put the pocket in, then put the hole in again on the pocket face? Or would you just put the pocket in after the hole in the model history, check the depth, and...