wphred's latest activity
-
Wwphred replied to the thread License check failed due to invalid system date. (SOLVED).The issue was with the system clock. I have a dual booted system; MX Linux on one hard drive, and Windows 11 on the other. Linux uses...
-
Wwphred posted the thread License check failed due to invalid system date. (SOLVED) in General Discussion.This is the error I get when trying to enter Alibre Design. It was working perfectly yesterday. The error screen had an EXIT icon and a...
-
Wwphred replied to the thread Drawing - how to dimension from middle of line to middle of arc (SOLVED).Is there something I should click on to show that this is solved? It will keep others from replying, although I have to say you Super...
-
Wwphred replied to the thread Drawing - how to dimension from middle of line to middle of arc (SOLVED).Harold, Thank you, once again.
-
Wwphred posted the thread Drawing - how to dimension from middle of line to middle of arc (SOLVED) in Using Alibre Design.In a drawing I'm trying to dimension from the middle of a line to the middle of an arc. The attached file shows a rocker for a doll...
-
-
Wwphred replied to the thread Creating a groove between two mortises - assigning points and using them.And Stephen, Thank you as well. Between you and Harold, I have some practice in my very near future. I just wish my memory was better...
-
Wwphred replied to the thread Creating a groove between two mortises - assigning points and using them.Harold, Thanks for schooling me (again)!! With more use and looking at more videos and tutorials, maybe I won't ask questions that have...
-
Wwphred replied to the thread Creating a groove between two mortises - assigning points and using them.What you have shown is what I have been doing with other parts, which are in the assembly. In 2D sketch mode I see no way to select...
-
Wwphred replied to the thread Creating a groove between two mortises - assigning points and using them.If you look at the model, one of the posts has three defined mortises. These were done by using the project to sketch function, using...
-
Wwphred posted the thread Creating a groove between two mortises - assigning points and using them in Using Alibre Design.I have a project where I need to create a groove (to hold a panel) between two mortises. I know I can create a rectangle on the face...
