Started with the 1st example at http://www.wizotools.com/tag/parameters/ and a simple 1x2x3 block. Wanting to run the script against a sheet metal part, released that the file extension AD_SMP added to the filename throws an error. It seams the extension AD_PRT is hard coded. Not expecting it...
Using the Contour Base Feature, that works.
When asking the question I was trying to start with a Tab Base Feature and added Flanges. Can it be done using this approach?
How do I have the dimension outside of a sheet metal bend be the driving (the specified) rather than the driven (the result)?
Ex: A strip of sheet metal is bent into a U shaped channel. The cross section is to be a 6 inch square on the outside.
Thanks, Bob