ericroberts197
Member
Imagine I sketch a feature as reference geometry and I fully constrain it. Now, say that geometry represented the shape of something entering the part. In the part I wish to make the cut out shape which it enters just a smidge larger. The obvious tool is the offset command. However, when you offset sketch none of the constraints come over to the offset feature. At that point you must re-constrain all the geometry without moving it...It becomes quite the challenge.
Any work around to this that I'm missing?
Alibre Atom3D
Version: V25 64-bit [Build 25037]
Any work around to this that I'm missing?
Alibre Atom3D
Version: V25 64-bit [Build 25037]
Last edited: