Search results

Even if I click "show", change it to right middle and unclick "show" it reverts to left middle.

That would make sense if I wanted a leader but the placement of a leaderless frame always defaults to Left-Middle. This is most unhelpful when attempting to place the frame on the left side of the part.

What am I missing here?

Thanks Harold. Looks like I was on the right track. Which is good in as far as the software is intuitive!

In the attached package I have an assembly with a part that I am trying to limit the range of motion between the ends of the slots. It is the last constraint on the tree. My first time attempting this in Alibre. Some help with this would be appreciated. Thank you. Benz

Two years later it is still confusing. I did find an answer though. Thanks.

Just found it. Wish there was a link in the "Explore" tab of the software. Something the help and learning section that says "What's New inV21" or whatever version it may be. As it is now it isn't even referenced in the knowledge base which I feel it should be.

Is there a "What's new" document?

Do you have any CAD/CAM experience at all outside of Alibre? Two dimensional flat CAD can be daunting as well if you are new to it. When I was learning Inventor the biggest hurdle I had was understanding the concept of constraints. But as others have said, the learning curve on any type of CAD...

I do believe this is what is happening. I too have never had this problem with parts I have created. Only imported parts. I am thinking that perhaps it is something with the software that generates the file.

Fortunately Lew the Navy doesn't really care how I model the fixturing of their parts as long as they get good parts. I use my models exclusively in the CAM realm for programming CNC's.:D

I too am using Mcmaster Carr models as well as others which are downloaded as STEP files, opened and saved as Alibre part files. They import easier that way. Doing the same thing you describe. However if I click on a diameter on one screw and then the hole it moves all the screws of that group...

After inserting multiples of a design(part) into an assembly I have found that constraining one of these constrains all of them. E.G: inserting two screws and aligning one of them to a hole results in both of them being aligned to the same hole. Has anyone else run into this?

Same issue here. The fatter, fuzzier elements are harder to pick. I agree, it's frustrating. Hopefully the service pack will address some of these issues.

I get an error when attempting to revert to build 20050: This occurs on my work computer (Win 7) or at home (Win 10).

Thanks

Wow! Big, big difference with the test build and AA off! Much better, much easier to interact with. I did do a restart after each registry change. Still seems a bit sluggish compared to 2018 though. With the AA off the ambient occlusion isn't nearly as distracting though I would rather it...

I find it difficult to select entities in a sketch mode. May be due to the fuzziness?

Nevermind, I found it.

Also, I turned on "Use Legacy Display". The display looks better in both 3D and 2D. However when creating a PDF it strips the dimensions out.