Search results

I had the same issue and rather similar to the other replies: Inserted a plane at the right angle (normal to the hole center axis), offset a new plane to be above the part. Inserted a point (used coordinate entry) to be at the surface of the part where I wanted the hole centerline to be Hole...

As far as I understand someone have to make an plug in for Open Office similar to the one for Excel. Anyway someone probably know more about this than me ;) Tore

I have not found a way to make it work with Open Office Org. Wish it would though. I am guessing that it is a rather simple task (for those who know how) to get Alibre to use OO in addition to Excel. I have requested this earlier to Alibre but did not get any reply. If you post an...

Rotate the part and have a look at the other side? Right-Click the sections view in d-explorer and see if "view" is checked? ? T

Re: Link did work now, same setup with Opera Version 7.54 that did not work earlier today. (get Opera at http://www.opera.com ;) ) Anyway - did work and I have done the survey. Tore

Link did not work for me.... Tore

Screen capture utility - AVI I am looking for a screen capture utility to record AVI (or mpeg or similar) to record from Alibre. Preferably low cost. Any recommendations? Any hints? Regards Tore

Re: That's why 3DC offer the SpaceTraveler. Recently there was new driver release. Alibre did offer a deal on 3DC products - not sure if there are any special offer at the moment. Could be an option to contact Alibre sales. Tore

New 3D Connexion driver 3D Connexion have a totally new version of the driver for the Space Traveler and most Space Balls - Dconnexion Software 1.0. I have signed up at 3D's to be notified about new releases, as I never have received any new release notes...