Alibre Points 3D and 2D Splines - Lines - Points

[GIOV]

Hi joachim,
Very cool the add on, I have discover it today from the forum searching an application for 2d points in a part. The units are only in millimeters,(inches) so if I need draw in meters I must multiply each points by 1000.
Thanks very much!

 

[GIOV]

Hi,
The add-ons "Alibre points" doesn't run in Assemble workspace for reference points. Someone here in the forum have a suggestion?
Thanks very much in advance

 

[GIOV]

Hi,
I have found that in the ADV:[ PRODUCTVERSION 2017.1.2 BUILD 18701 ] 64-bit, the Alibre Points still doesn't work in Assemble workspace for reference points and also is not in the insert from file's ribbon and menu as 3d points.

and still isn't included as creation Method into Insert point Tab....


Is there any news? or only I have mistaken in some steps.
Thanks,
GIOV