Has anyone done this successfully? I'm looking to put scale (1cm, 5cm, 10cm) lines and numbers along the length of a cylinder. I seem to be able to get the CAM to look and simulate correctly but not on the mill. I'll try any suggestions.
Ken
Alibre Design Expert 2017.1.2 64-bit Build 18701
AlibreCAM 2017 6.0.0.46
Milltronics VKM4 CNC mill w/ 8200B Controller w/ Troyke DL 6.6B Table
Ken
Alibre Design Expert 2017.1.2 64-bit Build 18701
AlibreCAM 2017 6.0.0.46
Milltronics VKM4 CNC mill w/ 8200B Controller w/ Troyke DL 6.6B Table