Analysis blockage

[papajoe41]

Hi,
I am being plagued with these 'open loop' problems. The analysis says that it is within the .000394 tolerance. How are the tolerances established? That is a really small difference. I read that the 'heal' command would fix these problems. Why is it grayed out? Have I not turned it on? The problem is highlighted to be that 'point' that was left when I took the corner out with the 'filet'. Is there anyway to delete the 'random points that are left after an operation?
Thanks,
Papajoe41

 

[bigseb]

It can't be healed because its a tiny little segment out on its own. Just delete it.

 

[simonb65]

Zoom in to this area to see what is really there and just delete it (circled in red) ...

 

[simonb65]

I suspect this is the 2nd open loop that needs deleting too ...

 

[DavidJ]

IF the open loop is repairable (i.e. a small gap in an otherwise closed sketch), then increasing the tolerance value will allow the Heal button to be come available.

If the open figure is a standalone line, then the heal will never become available.