Annotation number size

[Kunstmaan]

I am trying to get bigger numbers in the callout annotation,
In the file propeties I increasedthesize to 14pt but it doesnt show as such in the drawing.
Any suggestions

Mareike

 

[idslk]

 

[Kunstmaan]

View attachment 38835

If you open the drawing you could see that I had changed it allready to 14pt.
But I have tryed your solution In v26 but the result is the same, small numbers.

Mareike

 

[idslk]

i've opened the drawing again and these are your settings:


may you have forgotten to click apply?

Regards
Stefan

 

[Serenity]

If you open the drawing you could see that I had changed it allready to 14pt.
But I have tryed your solution In v26 but the result is the same, small numbers.

Mareike

It is important to note that within Drawing Properties there are a few different places where you can change the font/size to allow more granular control over the appearance of your drawing sheets. As mentioned above, make sure you adjust the size in the Annotations section and not the Dimensions section.