In Atom3D (27) I'm seeing an issue where mate offsets edited in the equation editor do not update in the assembly model. After editing mate offset values and exiting the editor the assembly does not update. Going into the individual constraints in the model tree the edited "new" value are shown in the value field. This shows that the value was transferred from the editor but the new value was not acted on. Even exiting the constraint with the new value showing the model does not update. In Atom I don't see the ability to roll back and then roll forward the model tree to force a full rebuild other than saving and exiting. Upon exiting and then reloading the new values are implemented. Is this a known limitation? Is there a way to force a full rebuild other than exiting?
