Blank display for 1680 x 1050 using Intel 82865G video card

[mkiner]

Blank display for 1680 x 1050 using Intel 82865G video card

Using:
Alibre Design Xpress 9.0 SP1
Intel 82865G graphics controller with latest driver

Problem:
Part/assembly design area is blank when I set the screen area of my display settings to 1680 x 1050, which is optimal for my monitor. Smaller areas seem to work fine.

Anyone have any information about this?

 

[siggy]

I doub't that Intel graphics controller can drive the display at a high enough refresh rate to display. You really need to get a stand alone video card...

Robert

 

[swertel]

Does it resemble the graphics problem another forum member recently had?
http://www.alibre.com/forums/viewtopic.php?t=2822

 

[mkiner]

Thanks, for the replies.

My problem does resemble http://www.alibre.com/forums/viewtopic.php?t=2822. However, switching to 16-bit color made no difference. I'll take you're advice, Robert.

 

[indesign]

Check in the properties>advanced>hardware acceleration

Make certain the slider is on full hardware acceleration.

Bet it's in a Dell. :roll: