jcdammeyer
Senior Member
I did this drawing two years ago. Since its 1020mm long it's kind of difficult to get any detail. And yet somehow I made these call outs.
I don't remember how I did it. Is there a tutorial on this somewhere? Or is it dirt simple?
Edit: Yes. Dirt simple as it turns out.
Select Insert|Partial View and select the view that needs a call out
Draw a circle around the area of interest and deselect the editor.
Select Insert|Detail View
Select the the previous view and then select the circle.
It creates what was inside the circle and then you can drag that out into a blank area.
It's listed in the contents as detail x
I don't remember how I did it. Is there a tutorial on this somewhere? Or is it dirt simple?
Edit: Yes. Dirt simple as it turns out.
Select Insert|Partial View and select the view that needs a call out
Draw a circle around the area of interest and deselect the editor.
Select Insert|Detail View
Select the the previous view and then select the circle.
It creates what was inside the circle and then you can drag that out into a blank area.
It's listed in the contents as detail x
Last edited: