Stu3d
Senior Member
I created 3 configurations of a computer keyboard key.
Everything is locked so changes don't propagate.
Height and angle changes are fine.
I label each key 1, F1 or Q so when I 3d print them I know where they go. I do this by editing the same sketch with the text in each configuration
When I looked back at each configuration they all had the same letter as the last one I created, in this case Q.
I did F1 in a slightly smaller font. The font size was remebered but there was a smaller Q instead of F1.
Is this a bug or are there limitations as to what you can change in a configuration?
Everything is locked so changes don't propagate.
Height and angle changes are fine.
I label each key 1, F1 or Q so when I 3d print them I know where they go. I do this by editing the same sketch with the text in each configuration
When I looked back at each configuration they all had the same letter as the last one I created, in this case Q.
I did F1 in a slightly smaller font. The font size was remebered but there was a smaller Q instead of F1.
Is this a bug or are there limitations as to what you can change in a configuration?