Can't select faces or edges upon reopenening assembly.
A new strange behavior I noticed after inserting a new subassembly. Upon reopening of the assembly I cannot select a face or axis for constraints or "Orient to Plane" reference. I can select reference geometry though. I get the little isometric symbol like the CTRL key is down.
As a workaround, if I go into edit a part and then go back again to edit root assembly, everything is normal again. If I reopen the assembly I have to do this again. It doesn't seem to matter what part I edit.
Thanks,
Eric
Sorry for so many posts lately.
A new strange behavior I noticed after inserting a new subassembly. Upon reopening of the assembly I cannot select a face or axis for constraints or "Orient to Plane" reference. I can select reference geometry though. I get the little isometric symbol like the CTRL key is down.
As a workaround, if I go into edit a part and then go back again to edit root assembly, everything is normal again. If I reopen the assembly I have to do this again. It doesn't seem to matter what part I edit.
Thanks,
Eric
Sorry for so many posts lately.
