beastro
Senior Member
Hi,
I would like to create a script to execute "physical properties", take Centre of gravity data from there and create a point relativ to the origin of the assembly representing that centre of gravity.
Each time the script is run again, it should depending on the preference either create a new point with a new name or update the existing point.
Has anybody done a similar script like this already which I could recycle?
Thanks and regards
I would like to create a script to execute "physical properties", take Centre of gravity data from there and create a point relativ to the origin of the assembly representing that centre of gravity.
Each time the script is run again, it should depending on the preference either create a new point with a new name or update the existing point.
Has anybody done a similar script like this already which I could recycle?
Thanks and regards