DerrickArdron
New Member
Hi, I am new to the Community and very much a learner with Alibre, using it for Model Engineering and DIY as in this case.
I am creating s simple cantilevered sliding gate with three panels surrounded by Rectangular Hollow Section Steel, (RHS). However the three panels are not identical in width.
Is it possible to use Alibre to fit diagonals to the three panels, or how else do I obtain the lengths of the diagonals and the cut angles at the end of the diagonals.
I am using the latest version of Alibre Professional.
Any help would be greatly appreciated
Many thanks
Derrick Ardron
I am creating s simple cantilevered sliding gate with three panels surrounded by Rectangular Hollow Section Steel, (RHS). However the three panels are not identical in width.
Is it possible to use Alibre to fit diagonals to the three panels, or how else do I obtain the lengths of the diagonals and the cut angles at the end of the diagonals.
I am using the latest version of Alibre Professional.
Any help would be greatly appreciated
Many thanks
Derrick Ardron