Creating reference from end of cylinder?
Hello again,
I cannot seem to get a reference off of the end of a cylinder. I guess because the ends are not really corners, but just look that way in the side view.
I'm trying to set a distance from the bottom of the cylinder for a set screw hole. I've tried creating a 3D section view (sucessfully) and then tried to do a project to sketch-nothing goes into the "entites to project" field.
It seems like it would be nice to have another option for section view such as hide rather than just view and delete, you you could easily turn it back on later, without having to recreate it.
Thanks for any help on this,
Eric
Hello again,
I cannot seem to get a reference off of the end of a cylinder. I guess because the ends are not really corners, but just look that way in the side view.
I'm trying to set a distance from the bottom of the cylinder for a set screw hole. I've tried creating a 3D section view (sucessfully) and then tried to do a project to sketch-nothing goes into the "entites to project" field.
It seems like it would be nice to have another option for section view such as hide rather than just view and delete, you you could easily turn it back on later, without having to recreate it.
Thanks for any help on this,
Eric