dmckee101
Alibre Super User
Didn't see this problem in a search so here goes:
Sometimes when adding a Datum to a 2d drawing, it will put the anchor on the correct surface but upside down. It is very repeatable when it happens, but I cannot determine what is causing it to snap this way. You can see in the jpg that you wouldn't draw the anchors that way, they are upside down.
Ideas anyone? (I've turned in a ticket FWIW.)
Sometimes when adding a Datum to a 2d drawing, it will put the anchor on the correct surface but upside down. It is very repeatable when it happens, but I cannot determine what is causing it to snap this way. You can see in the jpg that you wouldn't draw the anchors that way, they are upside down.
Ideas anyone? (I've turned in a ticket FWIW.)