I have been drawing my 2D sketches very carefully, trying to minimize DOF while drawing. However, I can't avoid finishing a sketch and still have some open items. I can use "Analyze" to sometimes find problems, but after that I end up trying to drag sketch elements around to see what moves. Unfortunately, frequently nothing will move, even though officially the sketch is not fully constrained.
So, the question is, are there any tips or tricks to finding these remaining DOF items?
Also, I sometimes feel that the automatic drawing constraints feature gets in my way, does anyone else feel this way?
Note: I am having strange results when trying to fillet an extrusion that was created with a DOF = 1 sketch, and I suspect that this is the source of the problem...
Thanks,
Jim
So, the question is, are there any tips or tricks to finding these remaining DOF items?
Also, I sometimes feel that the automatic drawing constraints feature gets in my way, does anyone else feel this way?
Note: I am having strange results when trying to fillet an extrusion that was created with a DOF = 1 sketch, and I suspect that this is the source of the problem...
Thanks,
Jim