Dimension Tags

[Dave H]

I have noticed with the new Alibre 2017 that when I start a sketch a tag is hanging from each line. Click on the tag and enter the dimension. I never saw this behavior until version 2017. I am not to fond of it. Is there a way to go back to just having the dimension dialog show up for dimension entry instead of the "dangling tags?'

 

[HaroldL]

Those "tags" are the DOF callouts and can be toggled off in the Sketch Options section of the Sketch Ribbon or hot keyed "Ctrl+Shift+U".
BTW, they've been there for a while, since v 2012 :? I think, they may not have been turned on before.

 

[Dave H]

Thank you Harold. I must have had them turned off, as you say, in my previous install. Then when I installed AD 2017, there they were!
Thanks. I appreciate it!