An assembly has two configurations and one BOM. When the associated drawing is created for each configuration, the BOM fails to maintain a unique configuration for each drawing. Each drawing configuration has the same BOM configuration, even when a BOM configuration is specified for each drawing and linked.
Apparently the BOM registers the configurations, but does not maintain association and unique differences.
If I update configuration-A BOM and then drawing configuration-B is opened, a message states a new BOM update has occurred and it reverts to configuration-A.
Is this a known BUG or is it in house.
Jeff
Apparently the BOM registers the configurations, but does not maintain association and unique differences.
If I update configuration-A BOM and then drawing configuration-B is opened, a message states a new BOM update has occurred and it reverts to configuration-A.
Is this a known BUG or is it in house.
Jeff