peterepeat
Member
Drawing Revision Block
Hi,
I am updating some sheetmetal parts and have to update a new revision of the drawing. It there some easy way of putting in revisions into the block, or do you have to draw a box, put in the notes and so on?
On a related note, is it possible to set the drawing to a specific revision level of a part from the repository (i.e. not the latest)
Regards,
Peter
Hi,
I am updating some sheetmetal parts and have to update a new revision of the drawing. It there some easy way of putting in revisions into the block, or do you have to draw a box, put in the notes and so on?
On a related note, is it possible to set the drawing to a specific revision level of a part from the repository (i.e. not the latest)
Regards,
Peter