Extrude cut problem

[pc-6]

I,m not sure why sketch 13 extrusion 10 will not work. I have put it through "analyze", I have redrawn it a couple of times and also tried creating a new plane with the drawing on it. None of the above will allow it to extrude cut properly. I am looking for the awnser to fix this aswell as I would like to know what to look for in solving this for future problems. The extrude cut should go through the entire part.
Thankyou
Leif

 

[pc-6]

Problem is all fixed. I don't know what happened but part was saved and closed, and upon re opening he problem went way, must have been some unknown bug.

Leif

 

[Ralf]

F5 is your friend.

 

[mudslutsoffroad]

I have the same problem sometimes. I usally just save it, and restart my comp, then it works fine.

 

[Ralf]

I usally just save it, and restart my comp, then it works fine.

It works fine if you press F5, restart is not necessary.

 

[pc-6]

Regenerating did not work for me. I tried everything I could think of and the only thing that worked was a shut down and restart of Alibre

 

[Desertrunner]

I find the same thing, normally I just need to close the drawing file and reopen it.
Tony