kineoptics
Senior Member
I am now experiencing frequent crashes while editing several sketches while in one assembly. It crashes it two ways. One is a dimension edit box gets stuck and return will not close it. I must then force quit. Another crash happens when finishing an edit to a sketch when clicking the sketch icon to get out of sketch mode. What could be the cause of this? Here are some possibilities.
I have noticed that AD has put some invisible constraints on lines and I have to delete the line and re-draw it to get it to move. Could these be a cause? I read on another post that this is normal and some users use the control key to sketch without these hidden constraints. But then one has to re-constrain the whole thing. Do many sketch like this? Is it easier to control and keep track of what is going on by manually constraining everything?
Also, I just installed the new Dell Nvidia driver for the M70, could be an issue but not sure.
I have noticed that AD has put some invisible constraints on lines and I have to delete the line and re-draw it to get it to move. Could these be a cause? I read on another post that this is normal and some users use the control key to sketch without these hidden constraints. But then one has to re-constrain the whole thing. Do many sketch like this? Is it easier to control and keep track of what is going on by manually constraining everything?
Also, I just installed the new Dell Nvidia driver for the M70, could be an issue but not sure.